/*
DMX_Master.ino - Example code for using the Conceptinetics DMX library
Copyright (c) 2013 W.A. van der Meeren <danny@illogic.nl>. All right reserved.
This library is free software; you can redistribute it and/or
modify it under the terms of the GNU Lesser General Public
License as published by the Free Software Foundation; either
version 3 of the License, or (at your option) any later version.
This library is distributed in the hope that it will be useful,
but WITHOUT ANY WARRANTY; without even the implied warranty of
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU
Lesser General Public License for more details.
You should have received a copy of the GNU Lesser General Public
License along with this library; if not, write to the Free Software
Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
*/
#include <Conceptinetics.h>
//
// CTC-DRA-13-1 ISOLATED DMX-RDM SHIELD JUMPER INSTRUCTIONS
//
// If you are using the above mentioned shield you should
// place the RXEN jumper towards pin number 2, this allows the
// master controller to put to iso shield into transmit
// (DMX Master) mode
//
//
// The !EN Jumper should be either placed in the G (GROUND)
// position to enable the shield circuitry
// OR
// if one of the pins is selected the selected pin should be
// set to OUTPUT mode and set to LOGIC LOW in order for the
// shield to work
//
//
// The master will control 100 Channels (1-100)
//
// depending on the ammount of memory you have free you can choose
// to enlarge or schrink the ammount of channels (minimum is 1)
//
#define DMX_MASTER_CHANNELS 100
//
// Pin number to change read or write mode on the shield
//
#define RXEN_PIN 2
// Configure a DMX master controller, the master controller
// will use the RXEN_PIN to control its write operation
// on the bus
DMX_Master dmx_master ( DMX_MASTER_CHANNELS, RXEN_PIN );
// the setup routine runs once when you press reset:
void setup() {
// Enable DMX master interface and start transmitting
dmx_master.enable ();
// Set channel 1 - 50 @ 50%
dmx_master.setChannelRange ( 1, 25, 127 );
}
// the loop routine runs over and over again forever:
void loop()
{
static int dimmer_val;
// Keep fading channel 1 in from 0 to 100%
dmx_master.setChannelValue ( 1, dimmer_val++ );
delay ( 100 );
}